HOME | CONTACT US | ABOUT TITAN | FAQ’s | INSTRUCTIONS | TERMS/SHIPPING | AWARDS | REVIEWS
Titan® Head Gasket Sealer:
Drain coolant system.
You can leave thermostat in-place or remove thermostat if you desire, doing so speeds
up entire the repair process.
Thermostat can be reinstalled
after the repair process is complete. After draining,
run clean
water through system
and re-drain. If you have tried another sealer always be sure to use our Titan
Flush Agent to remove any silicate-based sealers prior to starting the Titan repair process…
Next, add Titan Head Gasket Sealer
®
to system and fill with water. Start the engine and allow to idle with
sealers running through system for 20 minutes. Then turn-off engine and allow to cool. This is called a
“run-cycle” perform 3 run-cycles back-to-back then drive for 5-10 minutes keeping speeds below 45mph.
Then check progress of repair. You can continue these run-cycles and drive times until all symptoms have
been corrected or you have reached a total of 15 run-cycles. If all symptoms have been corrected,
drain sealer out of system and refill with new coolant/antifreeze. Some vehicles may require
more sealer to achieve a full-seal, contact us for a *free additional treatment if needed…
